|
Post by baileinneraora on Apr 10, 2018 18:03:06 GMT -5
I can’t seem to use anything other than splines to alter my designs in terms of fairways bunkers and greens. As for sculpting the landscape or adding trees and whatnot I simply cannot seem to be able to do so. I did recently complete a course which I published (Alva Golf Club) but while I like it, it is significantly handicapped by this. Does anyone know how to fix this issue.
|
|
|
Post by scampi00 on Apr 10, 2018 20:32:54 GMT -5
If I'm reading this right, you are at square one. Hover over your rough/fairways/greens and lower their width to 0. Then apply the surfaces by yourself. There are many tutorial videos available. Hope this helps.
|
|
|
Post by ErixonStone on Apr 12, 2018 10:10:56 GMT -5
About sculpting, be sure that you're using the Landscape tools and not the Sculpt tools. I recommend watching scampi's tutorial videos. They're short - each about 5 minutes in length - and informative. They're older and were created using TGC1 so the menus are different, but for learning how to get started and the basic dos and don'ts, they're very helpful. Scampi's Tutorial VideosThere are loads of other quality videos on YouTube, and informative Twitch streams by either Griff, Scarpacci or VctryLnSprts.
|
|
|
Post by culallen on Apr 16, 2018 14:50:05 GMT -5
If I'm reading his post correctly, I think I encountered the same thing. I was working on my Design Challenge course the other day. I tried to lay fairway with a brush, but about half of the area I selected stayed primitive rough. I tried several times with no results. I laid fairway spline over that area and it filled in, fine, but the brushes (blue) didn't work, and it was only across a random swath of the land. I had never experienced it before.
|
|
|
Post by ErixonStone on Apr 16, 2018 16:23:22 GMT -5
If I'm reading his post correctly, I think I encountered the same thing. I was working on my Design Challenge course the other day. I tried to lay fairway with a brush, but about half of the area I selected stayed primitive rough. I tried several times with no results. I laid fairway spline over that area and it filled in, fine, but the brushes (blue) didn't work, and it was only across a random swath of the land. I had never experienced it before. This happens when the base terrain is lower than the water table and then you use the blue landscaping brush to raise it. You have to use the red sculpt tools to raise the land, and then you can apply fairway/green.
|
|