|
Post by hershalcrustofsk on Mar 11, 2016 10:23:35 GMT -5
Just looking for some potential solutions to a problem I have from someone who may know more about the games technology than I do. So I've been working on a Highland Themed course on PS4 and am about 17 holes in, so 1 and a bit holes left with some detailing work as well. The problem is now, the game freezes almost instantly when I go to work on the course. In the past I've had courses where you get the error message every 20-30 mins, but on this one it just freezes. Any suggestions as to what I can do to get this course done, if I was 8 holes in I would just start something new, but I've put a ridiculous amount of time into this one.
Couple thoughts: -Object Meter is only at about a quarter (I've had ones that I get the error message frequently when the object meter gets over half, but shouldn't be the case on this one). Is there too much of a certain type of object that causes this. -I played a couple tests on the 17 holes and it runs very smooth, not a single laggy moment -Does publishing a beta and then editing the published version give me a decent chance of being able to finish this thing.
|
|
|
Post by mrooola on Mar 11, 2016 16:26:36 GMT -5
I have no answers for you, but I've seen similar issues and for me they went away after removing areas with multi planted grass or cart paths. I'm fairly sure it was the cart paths that did it for me.
I used a humongous amount of way points to make it smooth. They looked fine, but I could barely work in the designer. This was in the Copse btw so I did finish it
|
|
|
Post by hershalcrustofsk on Mar 12, 2016 0:44:05 GMT -5
I have no answers for you, but I've seen similar issues and for me they went away after removing areas with multi planted grass or cart paths. I'm fairly sure it was the cart paths that did it for me. I used a humongous amount of way points to make it smooth. They looked fine, but I could barely work in the designer. This was in the Copse btw so I did finish it Interesting thought, I also used a lot of waypoints and have never really used much for cart paths in the past. Going to delete some paths and just do them right at the end. I'll let you know if it allows me to work on the course. Regardless of what happens thanks for the idea Ola.
|
|
|
Post by hershalcrustofsk on Mar 14, 2016 12:45:54 GMT -5
I have no answers for you, but I've seen similar issues and for me they went away after removing areas with multi planted grass or cart paths. I'm fairly sure it was the cart paths that did it for me. I used a humongous amount of way points to make it smooth. They looked fine, but I could barely work in the designer. This was in the Copse btw so I did finish it Good call on the paths. I deleted 2 paths and it allowed me to work on the course again. Thanks for the idea, definitely going to allow me to finish up now.
|
|