|
|
Post by NCFCRulz on Apr 6, 2015 4:27:52 GMT -5
Hey to all good designers out there! Need help! Trying to put Rough in for a path and been able to do it on previous course but for some reason it wont do it for this one! I have tried altering Heavy Rough Width, flattening, raising and nothing seems to straighten it out. It is far straighter if I use Fairway surface but still not great! Any ideas?   |
|
|
|
Post by rod81simo on Apr 6, 2015 6:15:18 GMT -5
If you are referring to the wiggly edges it's because your size if brush is to big and the fading out of the brush being a little large makes the edge soft and wiggly. Try shrinking size down a bit. Also make sure that heavy rough width is set to zero as if it isn't it makes all the rough a little wiggly for some reason I have noticed.
|
|
|
|
Post by rod81simo on Apr 6, 2015 6:16:19 GMT -5
Also make sure you only stamp it once as the more you stamp it the more wiggly it will get also I have found. Anymore than 3 times and the edge goes to crap I find. Hope this is what you are referring to and sorts the issue
|
|
|
|
Post by NCFCRulz on Apr 6, 2015 7:39:26 GMT -5
Thanks for the replies. It does it no matter what size the brush is and have tried making zero heavy rough width and doesn't seem to make any difference!  |
|
|
|
Post by Bobgod09 on Apr 6, 2015 23:20:49 GMT -5
Having the same problem. Any light rough i use is distorted by heavy rough. No matter the brush. Is quite frustrating.
|
|
|
|
Post by dh-nufc on Apr 14, 2015 10:28:22 GMT -5
Have you tried raising and lowering the terrain using the red tool from the main menu rather than the yellow tool used in the contextual menu?
|
|
