Edit mode greens are different in Playtest mode

[rockerrk54]

I am new to this forum and this issue may have been adressed, but I am creating my first course and have two greens on sloped terrain that I have worked on to make both green pin's legal, (all green lines in the pin's tic tac toe box).  My problem/issue is that in edit mode I get no yellow or red lines in the pin's tic tac toe box, but when I playtest it there are yellow lines by the pin.  It appears that the editing I do in Edit mode does not show up in the Playtest mode.  I tried correcting this issue by saving the edits, but that has not resolved the problem.  I have been working on my course Offline.

Any thoughts or suggestions to resolve this issue would be greatly appreciated.  I have spent more hours than I care to admit creating my first course and if I'm not going to be able to publish it because of this issue, it is very frustrating!

[rob4590]

When you are editing, you only ever see the green grids from a specific angle - but when you play test, you see them from whatever angle your ball finishes - and the slopes can appear different in both. Basically you have to smooth them out sufficiently (around the hole) that they are green from all directions.

Usually done by flattening with the softest brush possible (page 4 of the blue flatten brushes) around the pins....

[rockerrk54]

Thank You for your response, I have been editing using that brush, and I have been trying to smooth my greens around the holes as you suggested. I will attempt to try it again and hope for better results as I would like to make my greens playable, but still keep them as challenging as possible. I have only had problems with these two holes that are very sloped. If I can't smooth these greens to my liking, I will probably flatten the entire green and start over, Thanks again.