Post by nifty1 on Dec 8, 2020 4:13:59 GMT -5
Hi folks
I'm working on my new course and it's mostly been going without a hitch. I have started to build the Tee boxes and all's been fine until I have arrived at hole 10.
I try and lay a fairway surface over the Tee's (after setting Tee box size to 0.00) and nothing is showing, it just stays as heavy rough.
It's the same on all 3 Tee boxes on the one hole, nothing appears.
All the rest of the holes have been fine with this and it's the same thing I have done on the other 3 courses I have built so far.
I move the brush away to anywhere else on the course and it lays the surface no problem.
I've had similar happen when the land was too close to the water table or a water body I had laid but I've always been able to raise the land a few inches then lay the surface no problem....that isn't working on this hole
Also, on the same hole, no matter where I put the middle way-point the game still selects a hybrid club off the Tee.
This was not happening until yesterday, the same hole has always selected the driver off the Tee whilst I have been building the course. I haven't changed the length of the hole, moved or laid any different surfaces, haven't moved the Tee boxes .... yet it only selects a lower club.
I know this is not a big issue as players can simply change the club up ... but it's annoying and I have no idea why it would suddenly start doing this.
Laying the fairway Tee boxes is more important to me really.
Has anyone any suggestions as to what might be happening, why I cannot lay fairway over heavy rough?
Thank you
I'm working on my new course and it's mostly been going without a hitch. I have started to build the Tee boxes and all's been fine until I have arrived at hole 10.
I try and lay a fairway surface over the Tee's (after setting Tee box size to 0.00) and nothing is showing, it just stays as heavy rough.
It's the same on all 3 Tee boxes on the one hole, nothing appears.
All the rest of the holes have been fine with this and it's the same thing I have done on the other 3 courses I have built so far.
I move the brush away to anywhere else on the course and it lays the surface no problem.
I've had similar happen when the land was too close to the water table or a water body I had laid but I've always been able to raise the land a few inches then lay the surface no problem....that isn't working on this hole
Also, on the same hole, no matter where I put the middle way-point the game still selects a hybrid club off the Tee.
This was not happening until yesterday, the same hole has always selected the driver off the Tee whilst I have been building the course. I haven't changed the length of the hole, moved or laid any different surfaces, haven't moved the Tee boxes .... yet it only selects a lower club.
I know this is not a big issue as players can simply change the club up ... but it's annoying and I have no idea why it would suddenly start doing this.
Laying the fairway Tee boxes is more important to me really.
Has anyone any suggestions as to what might be happening, why I cannot lay fairway over heavy rough?
Thank you