|
Post by timahhh2k21 on Oct 6, 2020 13:04:51 GMT -5
Hi.. this will make some of you roll your eyes I'm sure.. I was just practicing on a course and I'm actually happy with it and want to keep building.
Problem is I made a lake by hacking away with a round brush on Landscape Raise with a negative value to go below sea level. I now want to fill the lake in and get back to flat land so I can actually shape the lake properly. I jabbed away like a monkey so the actual bed is messy and jagged.
Ultimately I want to just dump a bunch of dirt in, level it off and start again. Any quick tips on the correct way to make a lake would be awesome too.
There is no way of creating a Landscape Lower from a spline? Thanks !
|
|
|
Post by Violinguy69 on Oct 6, 2020 13:38:38 GMT -5
Use the fuzziest brush (page 4 of brushes I think) on 'flatten' and raise it to about 4 feet. Then just spam it all over the lake. It'll rise right up to regular land height in no time.
|
|
|
Post by YouStayClassySanDiego on Oct 7, 2020 14:11:30 GMT -5
You could add a water body object into the void and adjust it to the right height. This is the method I did on two of my three lakes since the surrounding land is way above the bottom of the water table.
|
|